The SRG control units are for gas detection systems in areas such as boiler rooms, workshops, warehouses, laboratories, etc. It is designed to operate with natural gas (Methane), Carbon Monoxide (CO) and LPG. Sensor, The controller will isolate the gas solenoid valve via an internal relay and will operate an auxiliary device (siren, flasher, etc.) Alarm or failure is indicated by LED’s.
The SRG-4 can be connected to four of natural gas, Carbon Monoxide (CO) or LPG detectors.
NB The detectors can be used in any combination e.g 3 of Natural Gas and 1 of CO detector.
Detectors for SRG.4 control units
•Power supply is derived from the control unit.
◦Current input (at 6.5V): 40mA
◦Wiring-three core 1mm screen cable:
•Models and calibration: ◦Methane gas: CH4 Sensor, (default) 10% LIE of methane
◦LPG: LPG Sensor, (default) 12% LIE of isobutene
◦Carbon monoxide: CO Sensor, (default) 200ppm of CO
•Enclosure: self-extinguishing plastic material.
•Fastened to wall using screws and plastic plugs
•Ambient temperature: 0 ÷ +50°C
•Humidity: =90% R.H. without condensation
SRG-1-ZONE GAS CONTROL
£283.00 complete with a Wave LPG gas detector or a Wave Nat Gas detector.
£367.00 complete with a Wave Carbon Monoxide (CO) detector.
SRG-4-ZONE GAS CONTROL
SRG-4-ZONE GAS CONTROL – £332.00
£668.00 complete with any four of the following, Wave LPG gas detector or a Wave Nat Gas detector.
£1,004.00 complete with four off Wave Carbon Monoxide (CO) detector.
General Email Addresses:
Full Postal Address:
Telephone: 01702 384038
Facsimile: 01702 382340